Bush Hog HM2008, HM2007, HM2009 manual Optional hillside kit, Optional high skid

Page 39

①- ②

③- ④

Optional hillside kit

The spring lock keeps the machine in position in proportion to the tractor. If the machine meets a firm obstacle, the lock is released and the machine swings to the rear. Refer to the Hillside Kit Instructions for more information.

The spring lock must be adjusted. Screw (A) is eccentric. Tighten the bolt to minimum 225 mm (8-7/8”) Refer to Hillside Kit Instructions..

Optional high skid

The skids of the machine are fixed and cannot be height-adjusted. If the machine operates in fields with many stones, molehills, etc., high skids (B) and (C) are recommended. The cutting height is then increased to about 60 mm (2 -3/8”). Also refer to NOTE on page 25 for height adjust- ment.

Fitting: Set of skids, 2 pcs., are to be placed in the right hand and left hand side of the machine. They must be fitted below the fixed skids as shown in photos 3 and 4.

37

Image 39

Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions This Act Seeks Osha RegulationsChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Preparation For Use Do the following before coupling the machine to the tractorModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm PTO shaft Shortening of the shaftChecking of PTO shaft length Model HM2007 13mm 1/2 Model HM2008 11mm 7/16Model HM2009 8 mm 5/16 If the distance C is too big, raise the lift arm at D Height of the suspensionStabilizer Lifting heightPage Transport Unhitching TransportUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Maintenance Operate with safety note the followingKnives cutting discs Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil cutterbar Oil bevel gearboxOil level Plug D Swath Roller Optional equipment Right-hand & Left-hand swath rollersRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Special flat knives Throwing wingsLeft cone 2.8 mm Bevel gearbox Important, when fitting the gear to the machineDirections for repair Hydraulic lifting cylinderPage Synchronizing illustration CutterbarCollar bearings illustration Fixing of collar bearing ilustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Conversion Chart LubricantsTorque Value Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Gearbox Working Direction GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG