OTHER RECORDING FUNCTIONS
4.Keeping the camera pointed at the white sheet of paper, press DISP to make the manual white balance settings.
•Pressing SET at this time returns the camera to the white balance setting that was obtained the last time you performed this manual white balance procedure.
5.The manual white balance procedure stops au- tomatically when it is complete.
•If the manual white balance procedure does not end automatically, press SET to interrupt it.
6.After the camera finishes making the white bal- ance setting, it returns to the screen in step 3 above. Select “Exit” to exit the manual white balance procedure.
NOTE
White balance is automatically set to “Daylight” when- ever you enter the Night Scene Mode. You can leave this as it is or change it using the above procedure.
Specifying Power On Defaults
A power on default is one that is automatically used by the camera when you turn it on. You can specify power on de- faults for the recording mode, focus, flash, digital zoom, me- tering, white balance, and flash intensity.
The following tables show the items for which you can specify power on defaults. Note the following rules concern- ing power on defaults.
•There are two sets of power on defaults, named Mode 1 and Mode 2.
•When “On” is specified for an item, the camera remembers the current setting for that item when you turn off power, and uses the same setting when you turn power back on again.
•When “Off” is specified for an item, the camera always uses its standard power on default, as shown in the “Off” columns in the tables below.
