Bush Hog HM2008, HM2007, HM2009 manual 10 -30 mm 30 10.5 3 mm

Page 57

20.Attach limit chain and circular shield as shown in (Figure 17).

21.Attach Slow Moving Vehicle (SMV) bracket to three point lift hitch as shown. (Figure 18)

22.While leaving slack in hydraulic hose, clamp it to the three point lift hitch. (Figure 8)

23.Slide overunning clutch end of driveline onto Figure 16 Top Support

input shaft of hay mower. Insure that clutch end snaps into place.

24.The hook end of the safety chain will be attached to the tractor after the hay mower is mount- ed to the tractor three point hitch. The free end of the chain is then inserted through the bracket on the hitch frame of the hay mower. The loose end may then be reinserted back through the bracket to cap- ture the chain.(Figure 17)

10 -30 mm

30 - 10.5 - 3 mm

Figure 17 Retaining Spring

12 -40 mm

Figure 18

Slow Moving Vehicle Sign (SMV) Assembly

6 - 20 mm

Limit

Chain

12 - 40 mm

Circular Safety

Shield Chain

8 - 20 mm

10 - 30 mm

55

Image 57
Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions This Act Seeks Osha RegulationsChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Preparation For Use Do the following before coupling the machine to the tractorModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm PTO shaft Shortening of the shaftChecking of PTO shaft length Model HM2007 13mm 1/2 Model HM2008 11mm 7/16Model HM2009 8 mm 5/16 Stabilizer Height of the suspensionLifting height If the distance C is too big, raise the lift arm at DPage Transport Unhitching TransportUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Maintenance Operate with safety note the followingKnives cutting discs Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil cutterbar Oil bevel gearboxOil level Plug D Swath Roller Optional equipment Right-hand & Left-hand swath rollersRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Special flat knives Throwing wingsLeft cone 2.8 mm Directions for repair Important, when fitting the gear to the machineHydraulic lifting cylinder Bevel gearboxPage Collar bearings illustration CutterbarFixing of collar bearing ilustration Synchronizing illustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Conversion Chart LubricantsTorque Value Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Gearbox Working Direction GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG