Bush Hog HM2007, HM2008, HM2009 manual 10 35 mm 10 30 mm

Page 55

15.Assemble curtain frame as shown in (Figure 11). Do not attach curtain frame to upright bracket at this time.

Figure 11 Curtain Frame
10 - 35 mm	10 - 30 mm

Use Flatwasher

And Locknut On

Bottom Of Bolt

Top Support

Upright

Bracket

Shown without curtain for illustration only. Curtain must be installed over frame before curtain frame can be attached to upright bracket. Top sup- port is installed after curtain and frame are attached.

16. Place curtain over frame. Connect curtain Figure 12 Attaching Curtain Frame To Upright frame to upright mount with rubber and metal discs

“sandwiched” between the frame and mount. (Figure 12) Tighten “snug”, but allow to rotate.

17. Fasten rails to ends of frame as shown in (Figures 13, 14 and 15). Note that the rail on the inside end of the frame must be inserted through loops in the

curtain. (Figure 13)

Figure 13

10 - 30mm

Curtain Fabric Loops

53

Image 55

Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions Osha Regulations This Act SeeksChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Do the following before coupling the machine to the tractor Preparation For UseModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm Shortening of the shaft PTO shaftChecking of PTO shaft length Model HM2008 11mm 7/16 Model HM2007 13mm 1/2Model HM2009 8 mm 5/16 If the distance C is too big, raise the lift arm at D Height of the suspensionStabilizer Lifting heightPage Transport Transport UnhitchingUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Operate with safety note the following MaintenanceKnives cutting discs Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil bevel gearbox Oil cutterbarOil level Plug D Swath Roller Right-hand & Left-hand swath rollers Optional equipmentRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Throwing wings Special flat knivesLeft cone 2.8 mm Bevel gearbox Important, when fitting the gear to the machineDirections for repair Hydraulic lifting cylinderPage Synchronizing illustration CutterbarCollar bearings illustration Fixing of collar bearing ilustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Lubricants Conversion ChartTorque Value Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Working Direction Gearbox GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG