Bush Hog RMB 1865 manual Safety

Page 15
(SG-29)
(SG-26)
(SG-23)
(SG-15)
(SG-13)
(SG-12)

SAFETY

Do not mount or dismount the Tractor while the tractor is moving. Mount the Tractor only when the Tractor and all moving parts are completely stopped.

Start tractor only when properly seated in the Tractor seat. Starting a tractor in gear can result in injury or death. Read the Tractor operators manual for proper starting instructions.

Do not operate this Equipment with hydraulic oil or fuel leaking. Oil and fuel are explosive and their presence could present a hazard. Do not check for leaks with your hand! High-pressure oil streams from breaks in the line could penetrate the skin and cause tissue damage including gangrene. To check for a hose leak, SHUT the unit ENGINE OFF and remove all hydraulic pressure. Wear oil impenetrable gloves, safety glasses and use Cardboard to check for evidence of oil leaks. If you suspect a leak, REMOVE the HOSE and have it tested at a Dealer. If oil does penetrate the skin, have the injury treated immediately by a physician knowledgeable and skilled in this procedure.

Never run the Tractor engine in a closed building or without adequate ventilation. The exhaust fumes can be hazardous to your health.

SAFETY

Do not exceed the rated PTO speed for the Implement. Excessive PTO speeds can cause Implement driveline or blade failures resulting in serious injury or death.

Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat with the seat belt securely fastened around you. Inadvertent movement of the Tractor or Implement may cause serious injury or death.

In case of mechanical difficulty during operation, place the transmission in the park position, set the parking brake, shut down all power, including the PTO and the engine and remove the key. Wait until all rotating motion has stopped before dismounting. (SG-39)

RMB 1865 11/10

Safety Section 1-9

© 2010 Alamo Group Inc.

Image 15
Contents RMB To the Owner/Operator/Dealer Warranty InformationOsha Training Requirements Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Safety Section General Safety Instructions and Practices SafetyOperator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices RMB 1865 11/10 Safety Section Stop Mowing if Passersby are Within 300 Feet Unless Safety Safety SGM-06 Maintenance and Service Safety Instructions and Practices RMB 1865 11/10 Safety Section Parts Information Transporting Safety Instructions and PracticesSafety Concluding Safety Instructions and Practices Decal Location Reflect LogoName BookletInstruct MULTI-DECALNFS Serial Plate 3688303 Sharp Blades 09.821.35 Decal Description Safety Safety Model Name RMB Safety Safety Safety 3688303 RMB 1865 11/10 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection AssemblyFitting Operator Guard Tractor PreparationSWL. Leave in Position AT this Stage Dealer Setup InstructionsAttachment to Tractor Assembly Assembly Assembly Assembly Assembly Flailhead Attachment Running UP Procedure OIL RequirementsFitting Control Unit in CAB Storage Removal from TractorPage Operation Section Operation Standard Equipment and Specifications Standard SpecificationsMachine Specifications Personal Protective Equipment PPE Operator RequirementsTractor Requirements Rops and Seat BeltOperator Thrown Object Protection Tractor Ballast Tractor Lighting and SMV EmblemTractor Safety Devices Tractor Horsepower3-Point Hitch Hydraulics Front End WeightPower Take Off PTO Getting on and OFF the TractorDismounting the Tractor Boarding the TractorStarting the Tractor Tractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBoom Unit Pre-Operation Inspection and Service Frame Assembly Boom ARM AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Mower Boom Mower PRE-OPERATION Inspection Cable Controlled Models Only Lever Functions Machine ControlsOperation Reversing Rotation Rotor Controls-Gear Hydraulic Machine OnlyBreakaway With Auto Reset selectedPowered Slew Wire Trap Rotor Operating SpeedForward Speed High Voltage Cables Hedge Cutting ProcedureOperation Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Boom Foreign Debris Hazards Operating the Tractor and ImplementEngaging the Power Take Off PTO Bystanders/Passersby PrecautionsOperating the Mower Operating Speed and Ground SpeedSGM-08 Operating the Attached Mower Heads FlailSickle Bar Shutting Down the Attached Head OPS-B- 0012H TRACTOR, BOOM, and Attached Head StorageTransport Position Transporting the Tractor and ImplementOperation Transport POSITION-Head Removal Transport POSITION-Head AttachedTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section General LubricationOil Supply Filtration MaintenanceHydraulic System Hydraulic HosesHose Warranty Hose ReplacementCables Flail HeadPTO Gearbox Proper Torque Values for Fasteners Limited Warranty Required of the Operator Required of the OwnerRMB 1865 Rear Mount Boom Mower