Bush Hog RMB 1865 manual Boarding the Tractor, Dismounting the Tractor

Page 63
(SG-10)
(SG-12)

OPERATION

Do not mount or dismount the Tractor while the tractor is moving. Mount the Tractor only when the Tractor and all moving parts are completely stopped.

4.1 Boarding the Tractor

Use both hands and equipped handrails and steps for support when boarding the tractor. Never use control levers for support when mounting the tractor. Seat yourself in the operator’s seat and secure the seat belt around you.

Never allow passengers to ride on the tractor or attached equipment. Riders can easily fall off and be seriously injured or killed from falling off and being ran over. It is the operator’s responsibility to forbid all extra riders at all times. OPS-U- 0008

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

Never allow children to operate or ride on the Power Unit or Implement.

(SPU-17)

4.2 Dismounting the Tractor

Before dismounting, park the tractor and implement on a reasonably level surface, apply the parking brake, idle the engine down, disengage the PTO, and lower the implement to the ground. Shut down the tractor engine according to the operator’s manual, remove the key, and wait for all motion to completely stop. Never leave the seat until the tractor, its engine and all moving parts have come to a complete stop.

Use hand rails and steps when exiting the tractor. Be careful of your step and use extra caution when mud, ice, snow or other matter has accumulated on the steps or hand rails. Use all handrails and steps for support and never rush or jump off the tractor. OPS-U- 0009

BEFORE leaving the tractor seat lower the implement, set the parking brake and/or set the tractor transmission in parking gear, disengage the PTO, stop the engine, remove the key, and wait for all moving parts to stop. Place the tractor shift lever into a low range or parking gear to prevent the tractor from rolling. Never dismount a Tractor that is moving or while the engine is running. Operate the Tractor controls from the tractor seat only. (SG-9)

RMB 1865 11/10

Operation Section 4-9

© 2010 Alamo Group Inc.

OPERATION

Image 63
Contents RMB To the Owner/Operator/Dealer Warranty InformationOsha Training Requirements Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Safety Section General Safety Instructions and Practices SafetyOperator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices RMB 1865 11/10 Safety Section Stop Mowing if Passersby are Within 300 Feet Unless Safety Safety SGM-06 Maintenance and Service Safety Instructions and Practices RMB 1865 11/10 Safety Section Parts Information Transporting Safety Instructions and PracticesSafety Concluding Safety Instructions and Practices Decal Location Reflect LogoName BookletInstruct MULTI-DECALNFS Serial Plate 3688303 Sharp Blades 09.821.35 Decal Description Safety Safety Model Name RMB Safety Safety Safety 3688303 RMB 1865 11/10 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection AssemblyFitting Operator Guard Tractor PreparationSWL. Leave in Position AT this Stage Dealer Setup InstructionsAttachment to Tractor Assembly Assembly Assembly Assembly Assembly Flailhead Attachment Running UP Procedure OIL RequirementsFitting Control Unit in CAB Storage Removal from TractorPage Operation Section Operation Standard Equipment and Specifications Standard SpecificationsMachine Specifications Personal Protective Equipment PPE Operator RequirementsTractor Requirements Rops and Seat BeltOperator Thrown Object Protection Tractor Ballast Tractor Lighting and SMV EmblemTractor Safety Devices Tractor Horsepower3-Point Hitch Hydraulics Front End WeightPower Take Off PTO Getting on and OFF the TractorDismounting the Tractor Boarding the TractorStarting the Tractor Tractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBoom Unit Pre-Operation Inspection and Service Frame Assembly Boom ARM AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Mower Boom Mower PRE-OPERATION Inspection Cable Controlled Models Only Lever Functions Machine ControlsOperation Reversing Rotation Rotor Controls-Gear Hydraulic Machine OnlyBreakaway With Auto Reset selectedPowered Slew Wire Trap Rotor Operating SpeedForward Speed High Voltage Cables Hedge Cutting ProcedureOperation Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Boom Foreign Debris Hazards Operating the Tractor and ImplementEngaging the Power Take Off PTO Bystanders/Passersby PrecautionsOperating the Mower Operating Speed and Ground SpeedSGM-08 Operating the Attached Mower Heads FlailSickle Bar Shutting Down the Attached Head OPS-B- 0012H TRACTOR, BOOM, and Attached Head StorageTransport Position Transporting the Tractor and ImplementOperation Transport POSITION-Head Removal Transport POSITION-Head AttachedTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section General LubricationOil Supply Filtration MaintenanceHydraulic System Hydraulic HosesHose Warranty Hose ReplacementCables Flail HeadPTO Gearbox Proper Torque Values for Fasteners Limited Warranty Required of the Operator Required of the OwnerRMB 1865 Rear Mount Boom Mower