Bush Hog RMB 1865 manual Starting the Tractor, Brake and Differential Lock Setting

Page 82

OPERATION

OPERATION

15.1 Starting the Tractor

The procedure to start the tractor is model specific. Refer to the tractor operator’s manual for starting procedures for your particular tractor. Consult an authorized dealer if the starting procedure is unclear. Ensure the 3-point control lever is in the lowered position and the PTO is disengaged before starting the tractor. OPS-U-0033

15.2 Brake and Differential Lock Setting

Make sure the tractor brakes are in good operating condition. Tractor brakes can be set to operate independently allowing single rear wheel braking action or locked together to provide simultaneous rear wheel braking. FOR MOST DRIVING AND OPERATING CONDITIONS, THE BRAKE PEDALS SHOULD BE LOCKED TOGETHER TO PROVIDE THE MOST EFFECTIVE BRAKING ACTION.

Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or limit the tractor from turning. During normal cutting conditions, locking the differential provides no benefit and should not be used. OPS- U- 0013

Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes. When operating down a hill or on wet or rain slick roads, the braking distance increases; use extreme care and reduce your speed in these conditions. When operating in traffic, always use the Tractor’s flashing warning lights and reduce your speed. Be aware of traffic around you and watch out for the other guy.

RMB 1865 11/10

Operation Section 4-28

© 2010 Alamo Group Inc.

Image 82
Contents RMB Warranty Information To the Owner/Operator/DealerOsha Training Requirements Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Safety Section Safety General Safety Instructions and PracticesOperator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices RMB 1865 11/10 Safety Section Stop Mowing if Passersby are Within 300 Feet Unless Safety Safety SGM-06 Maintenance and Service Safety Instructions and Practices RMB 1865 11/10 Safety Section Transporting Safety Instructions and Practices Parts InformationSafety Concluding Safety Instructions and Practices Decal Location Booklet LogoName ReflectMULTI-DECAL InstructNFS Serial Plate 3688303 Sharp Blades 09.821.35 Decal Description Safety Safety Model Name RMB Safety Safety Safety 3688303 RMB 1865 11/10 Safety Section Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Assembly Tractor SelectionTractor Preparation Fitting Operator GuardDealer Setup Instructions SWL. Leave in Position AT this StageAttachment to Tractor Assembly Assembly Assembly Assembly Assembly Flailhead Attachment OIL Requirements Running UP ProcedureFitting Control Unit in CAB Removal from Tractor StoragePage Operation Section Operation Standard Specifications Standard Equipment and SpecificationsMachine Specifications Operator Requirements Personal Protective Equipment PPERops and Seat Belt Tractor RequirementsOperator Thrown Object Protection Tractor Lighting and SMV Emblem Tractor BallastTractor Horsepower Tractor Safety Devices3-Point Hitch Getting on and OFF the Tractor Front End WeightPower Take Off PTO HydraulicsBoarding the Tractor Dismounting the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/ServiceBoom Unit Pre-Operation Inspection and Service Boom ARM Assembly Frame AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Mower Boom Mower PRE-OPERATION Inspection Machine Controls Cable Controlled Models Only Lever FunctionsOperation Rotor Controls-Gear Hydraulic Machine Only Reversing RotationWith Auto Reset selected BreakawayPowered Slew Rotor Operating Speed Wire TrapForward Speed Hedge Cutting Procedure High Voltage CablesOperation Driving the Tractor and Implement Brake and Differential Lock Setting Starting the TractorDriving the Tractor and Boom Operating the Tractor and Implement Foreign Debris HazardsBystanders/Passersby Precautions Engaging the Power Take Off PTOOperating Speed and Ground Speed Operating the MowerSGM-08 Flail Operating the Attached Mower HeadsSickle Bar Shutting Down the Attached Head TRACTOR, BOOM, and Attached Head Storage OPS-B- 0012HTransporting the Tractor and Implement Transport PositionOperation Transport POSITION-Head Attached Transport POSITION-Head RemovalTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Troubleshooting Guide Trouble Possible Cause Possible RemedyOperation Operation Maintenance Section Lubrication GeneralHydraulic Hoses Filtration MaintenanceHydraulic System Oil SupplyHose Replacement Hose WarrantyFlail Head CablesPTO Gearbox Proper Torque Values for Fasteners Limited Warranty Required of the Owner Required of the OperatorRMB 1865 Rear Mount Boom Mower