Bush Hog RMB 1865 manual Starting the Tractor

(SG-13)

(SG-23)

OPERATION

OPERATION

5. STARTING THE TRACTOR

The operator must have a complete understanding of the placement, function, and operational use of all tractor controls before starting the tractor. Review the tractor operator’s manual and consult an authorized dealer for tractor operation instructions if needed.

Essential Tractor Controls:

•Locate the ignition key/switch

•Locate the engine shut off control

•Locate the hydraulic control levers

•Locate the light control lever

•Locate the brake pedals and clutch

•Locate the PTO control

•Locate the 3 point hitch control lever

•Locate the boom operating controls (joystick or valve bank)

Before starting the tractor ensure the following:

•Conduct all pre-start operation inspection and service according to the tractor operator’s manual.

•Make sure all guards, shields, and other safety devices are securely in place.

•The parking brake is on.

•The tractor transmission levers are in park or neutral.

•The boom operating controls are in the neutral and off position.

•The PTO control lever is disengaged.

•The hydraulic remote control levers are in the neutral position.

Refer to the tractor owner’s manual for tractor starting procedures. Only start the tractor while seated and belted in the tractor operator’s seat. Never bypass the ignition switch by short circuiting the starter solenoid. After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden and unexpected tractor movement. OPS-B- 0003

Never run the Tractor engine in a closed building or without adequate ventilation. The exhaust fumes can be hazardous to your health.

Start tractor only when properly seated in the Tractor seat. Starting a tractor in gear can result in injury or death. Read the Tractor operators manual for proper starting instructions.

RMB 1865 11/10 Operation Section 4-10

© 2010 Alamo Group Inc.