Meridian Audio FDP-DILA2 warranty Menu Operations

Menu Operations

Adjustment item	Button			Adjustment content
		Sets whether to clear the menu display automatically or not.
Menu display	2 or 3	15sec*		: Clears the display automatically in about 15 seconds.
		ON		: Does not automatically clear the menu display.
		Sets whether to show the line display (Y/C, VIDEO, COMP, PC1, PC2 or DVI) on top
Line display	2 or 3	right of the screen or not when the VIDEO or PC button is pressed.
		5sec*	: Shows the line display for about 5 seconds.
		OFF	: Does not show the line display.
		Displays the lamp use time.
		ON* : Displays when the lamp use time reaches 1000 hours when set in the LPC or
Lamp time display	2 or 3		LOC mode.
		OFF : Does not display when the lamp use time reaches 1000 hours when set in the
			LPC or LOC mode.3
		Press the ENTER button to enter the keystone submenu.
		In the keystone submenu, press 2 or 3 to correct trapezoidal distortion of the
		projected image. (–80 ↔ 0* ↔ +128)
Keystone	ENTER	To reset the keystone (trapezoidal distortion of the picture image) to the original
		setting (factory set value: 0), press the PRESET button when the “Keystone”
		submenu appears on the screen.
		To exit the keystone submenu, press the EXIT button.
		Press ENTER to enter the lamp control submenu.
		Normal*		: Used as a normal lamp.
		LPC		: Automatically controls the power used by the lamp and increases it in
				steps. When this mode is used, the brightness starts at approximately
				70%. The decrease in brightness is slower than in “Normal” mode and this
				mode is best suited when using the projector continuously for long periods
Lamp control	ENTER			of time.
				* “Lamp replacement” appears on the screen when the lamp use time
				exceeds 2000 hours.
		LOC		: The brightness can be set in seven levels (-6 to 0). Since the brightness
				can be set in steps, this is the mode best suited for adjusting multiple
				screens. This setting can also be changed while the projector is being
				used. To change the setting, choose LOC with the 5/∞ cursors and
				choose the level with the 2/3 cursors.
		Reverses image right-to-left.
Flip H	2 or 3	OFF*	: For the front method.
		ON	: For upside-down hanging from the ceiling.
		Inverses image upside-down.
Flip V	2 or 3	OFF*	: For normal setup.
		ON	: For upside-down hanging from the ceiling.
		Sets the baud rate for transmission.
RS-232C [bps]	2 or 3	9600		: 9600 bps
		19200*		: 19200 bps
Sleep time [min]	2 or 3	Sets the length of sleep time which automatically brings the projector into stand-by
		state. You can select one of the sleep times: 15, 30, 60 and 0 (OFF*) minutes.
* Factory set value

5Press the EXIT button to return to the previous menu or press the MENU button to exit the menu mode.

Note

• Refer to “Removing the Trapezoidal Distortion of the Image” on page 35 for more details about adjusting the keystone.

54