Meridian Audio FDP-DILA2 warranty Warning Indication, Action to be taken for warning indication

Warning Indication

If something abnormal has occurred with the projector, the warning status will be indicated by the combination of lighting the indicators on the control panel as shown in the following table. Then, the projector automatically stops projection and runs the cooling fan for about 120 seconds.

Warning indication table:

	No.			Indicator			Warning content
		LAMP	TEMP		STAND BY	OPERATE
1		Blink			Blink		The light-source lamp does not light and projection
							is not made.
2		Blink				Blink	The light-source lamp has suddenly gone off during
							projecting an image.
3		Blink	Blink				Circuit operation is abnormal.
4					Blink	Blink	The filter is displaced.
5			Blink				The internal temperature is too high. (Sensor 1)
6			Blink		Blink		The internal temperature is too high. (Sensor 2)
7		Blink	Blink		Blink	Blink	The cooling fan has stopped (locked).

* For individual indicator lighting, refer to page 58.

■Action to be taken for warning indication

Stopping the projector:

After the cooling fan has stopped, take the following action.

No. 1 : Check that the cover for replacing the light-source lamp and the front panel are securely attached, and then, press the OPERATE button for one second or more to turn on the projector for retrying.

No. 2 : Check that the cover for replacing the light-source lamp and the front panel are securely attached, and then, press the OPERATE button for one second or more to turn on the projector for retrying.

No. 3 : Press the OPERATE button for one second or more to turn on the projector for retrying.

Nos. 4-7 : Follow the next steps.

1.Turn off the MAIN POWER switch and unplug the power cord from the wall outlet.

2.Take an action according to the number.

No. 4 : Set the filter in place.Then, leave the projector until it cools down.

No. 5 : Check that nothing is blocking the air inlet nor outlet, and wait until the inside cools down.

No. 6 : Check that nothing is blocking the air inlet nor outlet, and wait until the inside cools down.

No. 7 : Leave the projector until it cools down.

3.Plug in the power cord again, turn on the MAIN POWER switch, and press the OPERATE button for one second or more to turn on the projector for retrying.

Retrying operation:

Plug in the power cord again and operate the projector.

If the same warning indication is observed again, after the cooling fan has stopped, turn off the MAIN POWER switch, unplug the power cord, and call your dealer for repair.

65