Meridian Audio FDP-DILA2 Adjusting Tracking/Phase, 1Press the MENU button, Menu Operations

Menu Operations

Adjusting Tracking/Phase

Normally, tracking and phase adjustments are automatically carried out when a video signal is input to the projector for the first time, or when the QUICK ALIGN. button on the remote control is pressed.

However, you can manually adjust the tracking and phase on the menu.

If a wide stripe appears on the screen, adjust the lateral size of the picture image and the display area (tracking adjustment) so the stripe disappears.

Also, if text projected on the screen appears flickers or appears dim, adjust phase adjustment so it becomes clear.

1Press the MENU button.

The main menu appears on the screen.

2Select “Set up” with the cursor button 5 or ∞, and press 3 or the ENTER button.

The “Set up 1” (video mode) or “Set up” submenu appears on the screen.

In video mode: Select set up 2 with the cursor ∞ or 5, and press ENTER button.

The “Set up 2” submenu appears on the screen.

Video submenu PC submenu

Set up 1			Set up 2
Position	ENTER		Tracking	123
Gamma	Down Cinema	Up	Phase	12
Aspect ratio	4:3	16:9	Screen	4:3	16:9
Decoder	ENTER		HDTV	1030i	1035i
Page 2	ENTER		Page 1	ENTER

Decoder is only displayed when there is a signal for the AV IN terminal.

Set up

Tracking	123
Phase	12
Position	ENTER
Resize	1:1	Panel	Aspect
Clamp	ST		BP

3

4

Select “Tracking” or “Phase” with the cursor button 5 or ∞.

Adjust the tracking or phase with the cursor 2 or 3.

Adjust the tracking and phase of the picture image being projected. To adjust the phase, first check for correct tracking adjustment.

*To adjust multiple items, repeat 3 and 4.

Adjustment item	Button	Adjustment content
Tracking	2 or 3	The picture image shrinks laterally (right-to-left) or extends laterally (left-to-
		right). (–128 ↔ +127)
Phase	2 or 3	Set to a position where text appears clear. (0 ↔ 31)

5Press the EXIT button to return to the previous menu or press the MENU button to exit the menu mode.

Note

•A dim image could be caused by insufficient adjustment of brightness and contrast. Before adjusting phase, make sure that brightness and contrast are correctly adjusted. To adjust them, refer to “Adjusting Picture Quality” on page 49.

46