Meridian Audio FDP-DILA2 Controls and Features, 9EXIT button, pPRESET button, qKEYSTONE / buttons

Controls and Features

9EXIT button

This button will be used in the menu mode to return to the previous menu. When the main menu is displayed, this button will cause the menu to disappear. For details, refer to “Basic Menu Operation” on page 43.

pPRESET button

This PRESET button only works as a reset button for the direct button adjustment of the KEYSTONE button of the control panel and the DIGITAL ZOOM button of the remote control. When adjusting the keystone or digital zoom (when the setting is displayed on the screen) the adjusted value is reset to that which was set when the projector was shipped from the factory. Of the menu items, this button only works for the keystone setting screen.

qKEYSTONE / buttons

Use these buttons to correct a trapezoidal distortion of the projected image. (Refer to page 35.)

wHIDE button

Use this button to turn off the image on the screen temporarily. Pressing it again restores the image to resume. (Refer to page 35.)

eLAMP indicator

ON : After the light-source lamp has been used for more than approx. 900 hours. (NORMAL only)

Blinking : After the light-source lamp has been used for more than approx. 1000 hours (1900 hours in the LPC or LOC mode). Replace the light-source lamp. Refer to “Replacing the Light-Source Lamp” on page 58 or page 59.

rTEMP indicator

Blinking : The temperature inside the projector has risen abnormally.

Note

•While the TEMP indicator is blinking (during abnormal temperature), the power is automatically cut off.

10