Operation
Product Overview
| Figure 4 |
| |
1. | Motion Control Lever | 5. | Controls |
2. | Parking Brake Lever | 6. | Seat Belt |
3. | 7. | Roll Bar | |
4.Fuel Cap (Both Sides)
Operation
Note: Determine the left and right sides of the machine from the normal operating position.
Controls
Motion Control Levers
The motion control levers located on each side of the console control the forward and reverse motion of the machine. The levers control the flow of hydraulic oil from the hydrostatic pump to the drive wheel motor for each side.
Moving the levers forward or backward turns the wheel on the same side forward or in reverse. Wheel speed is proportional to the amount the lever is moved.
Moving the levers outward from the center position into the
Throttle Control
Located on right fuel tank.
The throttle is used to control engine speed. Moving the throttle lever forward will increase engine speed and moving the throttle lever to the rear will decrease engine speed. Moving the throttle forward into the detent is full throttle.
Brake Lever
Located on left side of unit, just to the front of the console.
The brake lever engages a parking brake on the drive wheels.
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the brake.
The unit must be tied down and brake engaged when transporting.
Ignition Switch
Located on right fuel tank.
The ignition switch is used to start and stop the engine. The switch has three positions “OFF”, “ON”
19