Exmark 4500-501 Rev A manual Removing the Shim

Figure 25

4.Brake mounting bolt

Removing the Shim:

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake. Allow the machine to cool completely before starting these instructions.

2.Using a pneumatic line, blow out any debris from under the brake pole and around the brake spacers.

Figure 26

3.Check the condition of the wire harness leads, connectors, and terminals. Clean or repair as necessary.

4.Verify that 12V is present at the clutch connector when the PTO switch is engaged.

5.Measure the gap between the rotor and armature. If the gap is greater than .04 inch (1 mm), proceed with the following steps:

Figure 27

1.Brake mounting bolt

B.Using needle nose pliers, or by hand, take hold of the tab and remove the shim (Do Not discard the shim until proper clutch function has been confirmed).

Figure 28

1.Shim

C.Using a pneumatic line, blow out any debris from under the brake pole and around the brake spacers.

D.Re-torque each bolt (M6 x 1) to 10 ft-lb (13 N-m) +/-0.5 ft-lb (0.7 N-m).

E.Using a 0.010 inch thick feeler gauge, verify that a gap is present between the rotor and armature face on both sides of the brake pole