Maintenance
Important: It is essential that operator safety mechanisms be connected and in proper operating condition prior to use for mowing.
Check Rollover Protections Systems (Roll Bar) Knobs
Service Interval: Before each use or daily
Check that both the mounting hardware and the knobs are in good working condition. Make sure the knobs are fully engaged with the ROPS in the raised position. The upper hoop of the roll bar may need to be pushed forward or pulled rearward to get both knobs fully engaged.
| Figure 21 |
1. Engaged | 2. Partially engaged — Do |
| Not operate with ROPS |
| in this condition. |
|
|
Check Seat Belt
Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation of retractor and buckle. Replace before operating if damaged.
Check for Loose Hardware
Service Interval: Before each use or daily
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Visually inspect machine for any loose hardware or any other possible problem. Tighten hardware or correct the problem before operating.
Service Air Cleaner
Service Interval: Every 100
(May need more often under severe conditions. See the Engine Owner's Manual for additional information.)
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.See the Engine Owner's Manual for maintenance instructions.
Change Engine Oil
Service Interval: After the first 5 hours
Every 100 hours/Yearly (whichever comes first) (May need more often under severe conditions.)
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Drain oil while engine is warm from operation.
3.The oil drain hose is located on right hand side of engine at the rear. Place pan under machine to catch oil. Remove plug from end of drain hose. Allow oil to drain and replace oil drain plug. Torque plug to
4.Replace the oil filter every other oil change. Clean around oil filter and unscrew filter to remove. Before reinstalling new filter, apply a thin coating of Exmark
5.Clean around oil fill cap and remove cap. Fill to specified capacity and replace cap.
6.Use oil recommended in the Check Engine Oil Level section. Do Not overfill. Start the engine and check for leaks.
7.Wipe up any spilled oil from engine deck mounting surfaces.
Check Hydraulic Oil Level
Service Interval: Before each use or daily
31