Husqvarna WG4815E, WG3613E manual Checking the Parking Brake, Checking the V-belts, Deck belt

Page 43

MAINTENANCE

Checking the Parking Brake

Visually check that no damage is found on the neutral bail. Perform a test drive and check that there is sufficent braking action.

To adjust the handbrake, contact the service workshop if you are uncertain. Set the neutral bail in the neutral lock position. Tighten the wing nut. Check if the machine is braked, if not tighten the wing nut again.

Checking the V-belts

Deck belt

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

To replace belt lower the deck to its lowest position. Remove the plate and belt shields.

Use a ratchet with a 9/16” socket on the spring idler bolt to relieve the tension on the belt. Slide the belt off of pulley and fully remove the belt.

Reverse the proceedure for installation. See the decal on the top of deck for belt routing information.

After installation is complete check the belt for twists.

8011-477

The neutral bail in locked position

8011-775

Slackening the belt tensioner

English-41

Image 43

Contents WG4815E/968999120 WG3613E/968999117 Page WG3613E WG4815E OPERATOR’S Manual MowerEnglish-2 Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Keep a safe Safety Instructions Safety InstructionsGeneral Use Age of the user Do as follows Driving on SlopesDo not Children Maintenance Use protective glasses at maintenance work Customer responsibilities TransportControls ControlsControl Locations Recoil Starter Grip Ignition SwitchOperator Presence Levers Motion control leversNeutral Bail Gear shift leverParking Brake Choke Control USE Full Throttle When Mowing , forThrottle Control and Choke Control Blade Engagement LeverRefueling Fuel Shut-off Valve AccessoriesClose fuel valve at the end of each mowing job Operation OperationBefore Starting Starting the Engine Fuel shut-off valve, Open Presence lever Running GearboxTo operate on hills ReversingMowing Tips Mowing patterns Emergency stop StoppingNormal operating stop Stopping the Engine It may be necessary to readjust drive and brake linkages Adjustment of cutting heightCutting height table Axle Spacers Blade Position Spacers Height Caster arm Under cutter HousingAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance MaintenanceMaintenance Schedule 300 Ignition System Functional check Checking the Safety SystemChecking the Engines Cooling Air Intake Checking and Adjusting Throttle and Choke CableReplacing the Air Filter Checking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking Tire Pressures Checking the V-belts Checking the Parking BrakeDeck belt Checking the Blades Brake Rod AdjustmentUnder side of rear deck Caster Wheels Cleaning and WashingHardware Blade replacement Lubrication LubricationLubrication Schedule Front Wheel Bearings Lubricating the CablesLubricating in Accordance with the Lubrication Schedule Front Wheel MountEngine oil Changing the Engine Oil Changing the Oil FilterChecking the Oil Level Coupling Drive wheel idle arm, right and leftMower deck lever Rear wheel Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-52 Winter Storage ServiceStorage StorageWiring diagrams Wiring DiagramsTechnical data Technical DataWG3613E WG4815E Overall dimensions Torque SpecificationsUSA requirements Conformity CertificatesAfter the First 8 Hours Service JournalService Journal Delivery ServiceHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05