Husqvarna WG4815E, WG3613E manual Stopping the Engine

Page 31

OPERATION

Stopping the Engine

Allow the engine to idle a minute in order to attain normal operating temperature before stopping it, if it has been worked hard. Avoid idling the engine for longer periods, as there is a risk of the spark plugs fouling.

1.When the machine is standing still, set the neutral bail in the lock position.

2.Disengage the blades by pulling the blade egagement lever back.

8011-477

Parking brake

8011-474

Disengage the blades

3.Move the throttle to the minimum position (tortoise symbol). Turn the ignition key to

the stop position.

4. Remove the ignition key.

8011-475

Ignition key

5.Shut OFF the fuel valve.

IMPORTANT INFORMATION

Close fuel valve at the end of each mowing job.

8011-437

Fuel valve

English-29

Image 31

Contents WG4815E/968999120 WG3613E/968999117 Page WG3613E WG4815E OPERATOR’S Manual MowerEnglish-2 Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Keep a safe Safety Instructions Safety InstructionsGeneral Use Age of the user Do as follows Driving on SlopesDo not Children Maintenance Use protective glasses at maintenance work Customer responsibilities TransportControls ControlsControl Locations Recoil Starter Grip Ignition SwitchOperator Presence Levers Motion control leversNeutral Bail Gear shift leverParking Brake Choke Control USE Full Throttle When Mowing , forThrottle Control and Choke Control Blade Engagement LeverRefueling Fuel Shut-off Valve AccessoriesClose fuel valve at the end of each mowing job Operation OperationBefore Starting Starting the Engine Fuel shut-off valve, Open Presence lever Running GearboxTo operate on hills ReversingMowing Tips Mowing patterns Emergency stop StoppingNormal operating stop Stopping the Engine It may be necessary to readjust drive and brake linkages Adjustment of cutting heightCutting height table Axle Spacers Blade Position Spacers Height Caster arm Under cutter HousingAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance MaintenanceMaintenance Schedule 300 Ignition System Functional check Checking the Safety SystemChecking the Engines Cooling Air Intake Checking and Adjusting Throttle and Choke CableReplacing the Air Filter Checking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking Tire Pressures Checking the V-belts Checking the Parking BrakeDeck belt Checking the Blades Brake Rod AdjustmentUnder side of rear deck Caster Wheels Cleaning and WashingHardware Blade replacement Lubrication LubricationLubrication Schedule Front Wheel Bearings Lubricating the CablesLubricating in Accordance with the Lubrication Schedule Front Wheel MountEngine oil Changing the Engine Oil Changing the Oil FilterChecking the Oil Level Coupling Drive wheel idle arm, right and leftMower deck lever Rear wheel Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-52 Winter Storage ServiceStorage StorageWiring diagrams Wiring DiagramsTechnical data Technical DataWG3613E WG4815E Overall dimensions Torque SpecificationsUSA requirements Conformity CertificatesAfter the First 8 Hours Service JournalService Journal Delivery ServiceHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05