Husqvarna WG4815E, WG3613E manual Refueling

Page 21

CONTROLS

9. Refueling

The machine has one fuel tank. The tank volume is 5.3 gallons / 20 liters.

The engine should be run on a minimum of 87-octane unleaded gasoline (no oil mix). Also see Technical Data concerning methanol and ethanol fuels.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors

(see the safety rules).

.

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

When operating in temperatures below 32° F. (0° C.), use fresh, clean winter grade gasoline to help insure good cold weather starting.

8011-418

Fuel tank

IMPORTANT INFORMATION

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it the run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

English-19

Image 21
Contents WG4815E/968999120 WG3613E/968999117 Page WG3613E WG4815E OPERATOR’S Manual MowerEnglish-2 Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Keep a safe Safety Instructions Safety InstructionsGeneral Use Age of the user Driving on Slopes Do as followsDo not Children Maintenance Use protective glasses at maintenance work Customer responsibilities TransportControls ControlsControl Locations Recoil Starter Grip Ignition SwitchOperator Presence Levers Motion control leversGear shift lever Neutral BailParking Brake Throttle Control and Choke Control USE Full Throttle When Mowing , forBlade Engagement Lever Choke ControlRefueling Accessories Fuel Shut-off ValveClose fuel valve at the end of each mowing job Operation OperationBefore Starting Starting the Engine Fuel shut-off valve, Open Presence lever Running GearboxReversing To operate on hillsMowing Tips Mowing patterns Stopping Emergency stopNormal operating stop Stopping the Engine It may be necessary to readjust drive and brake linkages Adjustment of cutting heightCutting height table Axle Spacers Blade Position Spacers Height Caster arm Under cutter HousingAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance MaintenanceMaintenance Schedule 300 Ignition System Functional check Checking the Safety SystemChecking the Engines Cooling Air Intake Checking and Adjusting Throttle and Choke CableReplacing the Air Filter Replacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the Parking Brake Checking the V-beltsDeck belt Brake Rod Adjustment Checking the BladesUnder side of rear deck Cleaning and Washing Caster WheelsHardware Blade replacement Lubrication LubricationLubrication Schedule Lubricating in Accordance with the Lubrication Schedule Lubricating the CablesFront Wheel Mount Front Wheel BearingsEngine oil Changing the Engine Oil Changing the Oil FilterChecking the Oil Level Drive wheel idle arm, right and left CouplingMower deck lever Rear wheel Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-52 Storage ServiceStorage Winter StorageWiring diagrams Wiring DiagramsTechnical Data Technical dataWG3613E WG4815E Overall dimensions Torque SpecificationsUSA requirements Conformity CertificatesService Journal Service JournalDelivery Service After the First 8 HoursHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05