Husqvarna WG4815E, WG3613E manual Operation, Before Starting

Page 23

OPERATION

Operation

WARNING!

Be thoroughly familiar with all controls their function and how to operate them before operating the mower.

Before Starting

•Read the sections “Safety Instructions” on page 7, and “Controls” on page 14, before starting the machine.

•Perform the daily maintenance before starting (see “Maintenance Schedule” on page 34).

•Check that there is sufficient fuel in the fuel tank.

The following conditions must be fulfilled before the engine can be started:

•The control for engaging the blades must be in disengaged position.

•The neutral bail for the motion control levers must be in locked position.

WARNING!

Do not operate the mower if the interlock safety system allows operation or starting in any unsafe condition.

8011-474

Disengaged blades

8011-477

Neutral lock bail

English-21

Image 23

Contents WG4815E/968999120 WG3613E/968999117 Page WG3613E WG4815E OPERATOR’S Manual MowerEnglish-2 Introduction IntroductionManufacturing Number Good ServiceXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Symbols and DecalsSymbols and Decals Keep a safe General Use Safety InstructionsSafety Instructions Age of the user Do not Driving on SlopesDo as follows Children Maintenance Use protective glasses at maintenance work Customer responsibilities TransportControl Locations ControlsControls Recoil Starter Grip Ignition SwitchOperator Presence Levers Motion control leversParking Brake Gear shift leverNeutral Bail Choke Control USE Full Throttle When Mowing , forThrottle Control and Choke Control Blade Engagement LeverRefueling Close fuel valve at the end of each mowing job AccessoriesFuel Shut-off Valve Before Starting OperationOperation Starting the Engine Fuel shut-off valve, Open Presence lever Running GearboxMowing Tips ReversingTo operate on hills Mowing patterns Normal operating stop StoppingEmergency stop Stopping the Engine It may be necessary to readjust drive and brake linkages Adjustment of cutting heightCutting height table Axle Spacers Blade Position Spacers Height Caster arm Under cutter HousingAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance Schedule MaintenanceMaintenance 300 Ignition System Functional check Checking the Safety SystemChecking the Engines Cooling Air Intake Checking and Adjusting Throttle and Choke CableReplacing the Air Filter Checking Tire Pressures Replacing the Fuel FilterChecking the Fuel Pump’s Air Filter Deck belt Checking the Parking BrakeChecking the V-belts Under side of rear deck Brake Rod AdjustmentChecking the Blades Hardware Cleaning and WashingCaster Wheels Blade replacement Lubrication Schedule LubricationLubrication Front Wheel Bearings Lubricating the CablesLubricating in Accordance with the Lubrication Schedule Front Wheel MountEngine oil Changing the Engine Oil Changing the Oil FilterChecking the Oil Level Mower deck lever Drive wheel idle arm, right and leftCoupling Rear wheel Problem Cause Trouble Shooting GuideTrouble Shooting Guide English-52 Winter Storage ServiceStorage StorageWiring diagrams Wiring DiagramsWG3613E WG4815E Technical DataTechnical data Overall dimensions Torque SpecificationsUSA requirements Conformity CertificatesAfter the First 8 Hours Service JournalService Journal Delivery ServiceHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05