Husqvarna WG4815E, WG3613E manual Cleaning and Washing, Caster Wheels, Hardware

Page 45

MAINTENANCE

Cleaning and Washing

Regular cleaning and washing, especially under the mower deck, will increase the machine’s lifespan. Make it a habit to clean the machine directly after use, before the dirt sticks. Do not spray high pressure water directly on the top of the deck.

Caster Wheels

Check every 200 hours. Lift front of unit off of ground so caster wheels can rotate freely. Tighten caster bolt (34) then back off 1/2 turn. Check that wheel rotates freely. If wheel does not rotate freely, back the caster bolt off in 1/4 turn increments until wheel rotates freely.

IMPORTANT INFORMATION

DO NOT add any type of tire liner or foam fill material to the tires. Excessive loads created by foam filled tires will cause premature failures.

Only use O.E.M. specified tires.

Foam filled tires or solid tires will void the warranty.

Hardware

Check daily. Inspect the entire machine for loose or missing hardware.

8011-639

Cleaning

8011-619

Caster wheels

English-43

Image 45
Contents WG4815E/968999120 WG3613E/968999117 Page WG3613E WG4815E OPERATOR’S Manual MowerEnglish-2 Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Keep a safe Safety Instructions Safety InstructionsGeneral Use Age of the user Driving on Slopes Do as followsDo not Children Maintenance Use protective glasses at maintenance work Customer responsibilities TransportControls ControlsControl Locations Recoil Starter Grip Ignition SwitchOperator Presence Levers Motion control leversGear shift lever Neutral BailParking Brake Throttle Control and Choke Control USE Full Throttle When Mowing , forBlade Engagement Lever Choke ControlRefueling Accessories Fuel Shut-off ValveClose fuel valve at the end of each mowing job Operation OperationBefore Starting Starting the Engine Fuel shut-off valve, Open Presence lever Running GearboxReversing To operate on hillsMowing Tips Mowing patterns Stopping Emergency stopNormal operating stop Stopping the Engine It may be necessary to readjust drive and brake linkages Adjustment of cutting heightCutting height table Axle Spacers Blade Position Spacers Height Caster arm Under cutter HousingAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance MaintenanceMaintenance Schedule 300 Ignition System Functional check Checking the Safety SystemChecking the Engines Cooling Air Intake Checking and Adjusting Throttle and Choke CableReplacing the Air Filter Replacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the Parking Brake Checking the V-beltsDeck belt Brake Rod Adjustment Checking the BladesUnder side of rear deck Cleaning and Washing Caster WheelsHardware Blade replacement Lubrication LubricationLubrication Schedule Lubricating in Accordance with the Lubrication Schedule Lubricating the CablesFront Wheel Mount Front Wheel BearingsEngine oil Changing the Engine Oil Changing the Oil FilterChecking the Oil Level Drive wheel idle arm, right and left CouplingMower deck lever Rear wheel Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-52 Storage ServiceStorage Winter StorageWiring diagrams Wiring DiagramsTechnical Data Technical dataWG3613E WG4815E Overall dimensions Torque SpecificationsUSA requirements Conformity CertificatesService Journal Service JournalDelivery Service After the First 8 HoursHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05