Husqvarna WG4815E, WG3613E manual Lubricating the Cables, Front Wheel Mount, Front Wheel Bearings

Page 48

LUBRICATION

Lubricating the Cables

If possible, lubricate both ends of the cables and move the controls to end stop positions when lubricating. Refit the rubber covers on the cables after lubrication. Cables with sheaths will bind if they are not lubricated regularly. If a cable binds, it can disrupt operation.

If a cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins to escape from the bottom.

Hint!: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.

Lubricating in Accordance with the Lubrication Schedule

1. Front Wheel Mount

Lubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

2. Front Wheel Bearings

Lubricate with a grease gun, one zerk for each set of wheel bearings, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

3.Throttle and Choke Cable, Lever Bearings

Lubricate the cable end at the carburetor with the oil can. Move the controls to the end points and lubricate again.

The throttle cable is also lubricated at the control when the control console is removed.

8011-573

Lubricating the front wheels

8011-485

Throttle and choke cable by the carburetor

English-46

Image 48
Contents WG4815E/968999120 WG3613E/968999117 Page OPERATOR’S Manual Mower WG3613E WG4815EEnglish-2 Introduction IntroductionGood Service Manufacturing NumberSymbols and Decals Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Keep a safe Safety Instructions Safety InstructionsGeneral Use Age of the user Driving on Slopes Do as followsDo not Children Maintenance Use protective glasses at maintenance work Transport Customer responsibilitiesControls ControlsControl Locations Ignition Switch Recoil Starter GripMotion control levers Operator Presence LeversGear shift lever Neutral BailParking Brake USE Full Throttle When Mowing , for Throttle Control and Choke ControlBlade Engagement Lever Choke ControlRefueling Accessories Fuel Shut-off ValveClose fuel valve at the end of each mowing job Operation OperationBefore Starting Starting the Engine Fuel shut-off valve, Open Presence lever Gearbox RunningReversing To operate on hillsMowing Tips Mowing patterns Stopping Emergency stopNormal operating stop Stopping the Engine Adjustment of cutting height It may be necessary to readjust drive and brake linkagesSpacers Height Caster arm Under cutter Housing Cutting height table Axle Spacers Blade PositionAxle Spacers Blade Cutting Position Moving machine by Hand Maintenance MaintenanceMaintenance Schedule 300 Ignition System Checking the Safety System Functional checkChecking and Adjusting Throttle and Choke Cable Checking the Engines Cooling Air IntakeReplacing the Air Filter Replacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the Parking Brake Checking the V-beltsDeck belt Brake Rod Adjustment Checking the BladesUnder side of rear deck Cleaning and Washing Caster WheelsHardware Blade replacement Lubrication LubricationLubrication Schedule Lubricating the Cables Lubricating in Accordance with the Lubrication ScheduleFront Wheel Mount Front Wheel BearingsChanging the Oil Filter Engine oil Changing the Engine OilChecking the Oil Level Drive wheel idle arm, right and left CouplingMower deck lever Rear wheel Trouble Shooting Guide Trouble Shooting GuideProblem Cause English-52 Service StorageStorage Winter StorageWiring Diagrams Wiring diagramsTechnical Data Technical dataWG3613E WG4815E Torque Specifications Overall dimensionsConformity Certificates USA requirementsService Journal Service JournalDelivery Service After the First 8 HoursHour Service English-60 English-61 English-62 At Least Once Each Year 106457R0108/11/05