Husqvarna Robotic Lawn Mowe manual Checking the installation

Page 33

3. Installation

5.Cut off any surplus boundary wire. Cut 1 - 2 cm above respective connectors.

6.Press the connector onto the contact pin, marked A, on the charging station.

IMPORTANT INFORMATION

The right hand connector should be connected on the right hand contact pin on the charging station and vice versa.

7.Refit the cover on the charging station. Ensure the three guides on the charging station enter the right holes in the cover.

3.6 Checking the installation

Check the loop signal by looking to see what indication the green LED on the charging station is giving.

•Steady light = the signal is okay.

•Flashing once every other second = break in the loop and no signal found.

•Flashing twice every other second = signal found, but the wire is probably damaged. Check all wire connections.

3012-265

3012-507

3012-270

3012-282

Automower from

™ 33

Image 33

Contents Operator’s manual Page Table of contents Table of contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualUse Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular Search method 2 Follow loop Search method 3 Follow guide wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationInstallation of the charging station PreparationsIdeal position of the charging station Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Installation of the boundary wireBest position for the boundary wire Boundaries for the working area 30 cm10 cm Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire3012-284 3012-264 Checking the installation Installation of the guide wire Need of a guide wireLinking the Automower to the charging station 3012-669 Placement and connection of the guide wire Maximum 3012-675 Use Charging a discharged batteryUsing the timer Starting the AutomowerStopping the Automower Restart Switching off the AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower Automower main menuTimer CommandsTimer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width When Test in 3-2-4 is used, the house icon TestTest OUT Open Garden shapeNormal ComplexDrive past wire AdvancedCheck loop Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageTime and date Garden shape Open Garden example proposed installation and settingsCorridor width Guide wire Garden shape Normal Proportion 40 % Distance 40 m and Proportion 20 %. Area3012-530 Maintenance Service BatteryWinter storage AutomowerCleaning After winter storageUnderframe and blade disc Replacing the blades Do not use running water when cleaningChassis Wheels3012-260 Fault messages Trouble shootingTrouble shooting Results Symptom Cause Action Uneven mowingAutomower runs at Wrong timeTechnical data Environmental InformationData Automower from Husqvarna EU Declaration of Conformity only applies to Europe EU declaration of conformityEU declaration of conformity Auto IndexMain menu 43, 47 Start Automower Working area Boundaries Automower from Automower from Page 2005W48