3. Installation
•The boundary wire runs along a steep slope (steeper than 35 %).
When Automower follows the boundary wire that runs along a steep slope, the mower will change direction and run away from the boundary wire.
•Numerous or large islands.
If Automower is permitted to follow the boundary wire it may circle an island roughly twice before it leaves the island and once again searches for the boundary wire.
•The route to a remote area is long or complicated.
When Automower shall follow the boundary wire to or from a remote area and the route along the boundary wire to the area is long or complicated.
•The boundary wire runs across a long slope (steeper than 10 %).
When Automower follows the boundary wire across a slope (steeper than 10 %) the mower must compensate for the slope. The mower then follows the boundary wire at a slower speed. The risk of the mower running outside of the working area due to skidding increases.
•The charging station is positioned on an island.
When there is more than 4 metres between the charging station and the outer edge of the boundary wire, it can take a long time for Automower to find the charging station when it follows the boundary wire. There is a risk of the mower following the outer edge of the working area 2 - 3 turns before it changes direction and starts to follow the loop at another spot.
|
Automower from | ™ 35 |