Husqvarna Robotic Lawn Mowe More than one Automower in a garden, One Automower in several gardens

Page 17

2. Presentation

2.4More than one Automower in a garden

If you install more than one Automower in the same area of lawn, each mower must have its own PIN code. However, if the boundary wires are laid at least 40 cm from each other the mowers can have the same PIN code. This will mean that about 20 cm between the working areas will not be mowed.

Contact your dealer for further information.

2.5One Automower in several gardens

One Automower can easily be used for more than one garden, where each garden has its own charging station and boundary wire. The mower can then have the same PIN code for all gardens.

Contact your dealer for further information.

Automower from

17

Image 17
Contents Operator’s manual Page Table of contents Table of contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualUse Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Mowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 2 Follow loop Search method 3 Follow guide wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationIdeal position of the charging station Installation of the charging stationPreparations Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Best position for the boundary wire Charging the batteryInstallation of the boundary wire Boundaries for the working area 30 cm10 cm Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire3012-284 3012-264 Checking the installation Linking the Automower to the charging station Installation of the guide wireNeed of a guide wire 3012-669 Placement and connection of the guide wire Maximum 3012-675 Use Charging a discharged batteryStopping the Automower Using the timerStarting the Automower Restart Switching off the AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower Automower main menuTimer CommandsWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT When Test in 3-2-4 is used, the house iconTest Open Garden shapeNormal ComplexCheck loop Drive past wireAdvanced Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageTime and date Garden shape Open Garden example proposed installation and settingsCorridor width Guide wire Garden shape Normal Proportion 40 % Distance 40 m and Proportion 20 %. Area3012-530 Maintenance Service BatteryWinter storage AutomowerUnderframe and blade disc CleaningAfter winter storage Replacing the blades Do not use running water when cleaningChassis Wheels3012-260 Fault messages Trouble shootingTrouble shooting Results Symptom Cause Action Uneven mowingAutomower runs at Wrong timeData Automower from Husqvarna Technical dataEnvironmental Information EU Declaration of Conformity only applies to Europe EU declaration of conformityEU declaration of conformity Auto IndexMain menu 43, 47 Start Automower Working area Boundaries Automower from Automower from Page 2005W48