Husqvarna Robotic Lawn Mowe manual 3012-675

Page 38

3. Installation

11.Connect the guide wire to the boundary wire with the help of a solderless coupler:

Insert the ends of the boundary wire in the right respective left-hand holes on the connector.

Insert the end of the guide wire in the centre hole.

Press down the button on the connector fully.

12.Staple down/bury the connector in the lawn.

IMPORTANT INFORMATION

The function of the guide wire varies depending on how the working area appears. It is therefore recommended to test the installation with the help of the function Test OUT (3-2-5), see page 57.

3012-675

38 Automower from

Image 38
Contents Operator’s manual Page Table of contents Table of contents Introduction and safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxSafety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toMowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 3 Follow guide wire Search method 2 Follow loopMore than one Automower in a garden One Automower in several gardensInstallation Carry out the installation in the following stepsIdeal position of the charging station Installation of the charging stationPreparations Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Best position for the boundary wire Charging the batteryInstallation of the boundary wire 30 cm Boundaries for the working area10 cm Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire3012-284 3012-264 Checking the installation Linking the Automower to the charging station Installation of the guide wireNeed of a guide wire 3012-669 Placement and connection of the guide wire Maximum 3012-675 Charging a discharged battery UseStopping the Automower Using the timerStarting the Automower Restart within 20 seconds Switching off the AutomowerRestart Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Programs SelectMain switch NumbersBrowse between menus Menu functionsMain menu Number seriesAutomower main menu AutomowerCommands TimerWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT When Test in 3-2-4 is used, the house iconTest Normal Garden shapeOpen ComplexCheck loop Drive past wireAdvanced PIN code SettingsSecurity Time lockStop protection Operation Settings lockSounds KeypadLanguage Sound SignificanceTime and date Garden example proposed installation and settings Garden shape OpenCorridor width Guide wire Garden shape Normal Distance 40 m and Proportion 20 %. Area Proportion 40 %3012-530 Maintenance Winter storage BatteryService AutomowerUnderframe and blade disc CleaningAfter winter storage Chassis Do not use running water when cleaningReplacing the blades Wheels3012-260 Trouble shooting Fault messagesTrouble shooting Automower runs at Symptom Cause Action Uneven mowingResults Wrong timeData Automower from Husqvarna Technical dataEnvironmental Information EU declaration of conformity EU Declaration of Conformity only applies to EuropeEU declaration of conformity Index AutoMain menu 43, 47 Start Automower Working area Boundaries Automower from Automower from Page 2005W48