Husqvarna Robotic Lawn Mowe manual Symbols in the Operator’s Manual, Xxxxxx xxxxx xxxx xxxx xxxxx

Page 7

1. Introduction and safety

1.3Symbols in the Operator’s Manual

These symbols can be found in the Operator’s Manual. Study them carefully so you understand their significance.

•Inspection and/or maintenance must be carried out with the main switch set to OFF.

•Always wear protective gloves when working with the mower’s underframe.

•Never use a high-pressure washer or even running water to clean the Automower.

•A warning box indicates a risk of personal injury exist, especially when the stated instructions are not followed.

•An information box indicates a risk of material damage exist, especially when the stated instructions are not followed. The box is also used where there is a risk of user error.

3012-288

3012-272

3012-271

WARNING

Xxxxxx xxxxx xxxx xxxx xxxxx xxx.

IMPORTANT INFORMATION

Xxxxxx xxxxx xxxx xxxx xxxxx xxx.

Automower from

™

7

Image 7

Contents Operator’s manual Page Table of contents Table of contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualUse Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 2 Follow loop Search method 3 Follow guide wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationPreparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 30 cm10 cm Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire3012-284 3012-264 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station 3012-669 Placement and connection of the guide wire Maximum 3012-675 Use Charging a discharged batteryStarting the Automower Using the timerStopping the Automower Restart after more than 20 seconds Switching off the AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchNumber series Menu functionsMain menu Browse between menusAutomower Automower main menuTimer CommandsDay timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Complex Garden shapeOpen NormalAdvanced Drive past wireCheck loop Time lock SettingsSecurity PIN codeStop protection Keypad Settings lockSounds OperationSound Significance LanguageTime and date Garden shape Open Garden example proposed installation and settingsCorridor width Guide wire Garden shape Normal Proportion 40 % Distance 40 m and Proportion 20 %. Area3012-530 Maintenance Automower BatteryService Winter storageAfter winter storage CleaningUnderframe and blade disc Wheels Do not use running water when cleaningReplacing the blades Chassis3012-260 Fault messages Trouble shootingTrouble shooting Wrong time Symptom Cause Action Uneven mowingResults Automower runs atEnvironmental Information Technical dataData Automower from Husqvarna EU Declaration of Conformity only applies to Europe EU declaration of conformityEU declaration of conformity Auto IndexMain menu 43, 47 Start Automower Working area Boundaries Automower from Automower from Page 2005W48