3Com 09-1632-000 manual Cable the Ethernet Connector, Cable the Serial Port

8CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER

Figure 3 OfficeConnect Back Panel Connectors

			20-XXXX-XXX	3CXXXXX	OFFICECONNECT
	12-24V DC		II I II III IIIII IIIIII	XXXV000000	Model: ESPL-XXX
					NETBuilder XXX XXX
	1A MAX		II I II III IIIII II	08002 XXXXXX
				THRU XXXXXX
+	TP	Console	Serial		WAN
–

LAN Ethernet	9-pin serial	Flex-WAN	WAN
connections	connection	connector to	line
(connect only one)	to terminal or	modem
	PC serial port	or CSU/DSU

Cable the Ethernet Connector

The OfficeConnect bridge/router accepts either a 10BASE-2 coaxial or 10BASE-T twisted pair (TP) Ethernet cable connection.

Attach a coaxial Ethernet cable to the BNC connector using a T-connector, or plug the 8-foot twisted pair cable supplied with the OfficeConnect bridge/router into the slot labeled TP.

Only one Ethernet connection is allowed.

Cable the Serial Port

Attach the special 3Com Flex-WAN cable to the port labeled Serial.

Attach the Flex-WAN end of the cable to the OfficeConnect bridge/router port. The other end of the cable has the appropriate connector (V.35, X.21, or RS-232) for a serial modem or CSU/DSU device.

You should have ordered the Flex-WAN cable when you ordered your OfficeConnect bridge/router. You can order a Flex-WAN cable from your local 3Com sales representative.

Plug the CSU/DSU or modem cable into the connector on the Flex-WAN cable. Connect the CSU/DSU or modem to the leased line provided by your telco vendor.