22CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER
cClick Apply.
10Add a default route to port 4 to tell the OfficeConnect NETBuilder bridge/router which port to use to communicate to the internet
a In the Basic IP section of the navigation frame, click IP Route.
b In the ROUte field, enter the route:
0.0.0.0!4 1
cClick Apply.
11In the Policy Management Network Address Translation section on the navigation frame, click the NAT IPCPAddressMap link.
a In the start field, choose 4.
b In the IPCPAddressMap field, enter Enable. c Click Apply.
12In the Policy Management Network Address Translation section on the navigation frame, click the NAT CONTrol link.
a In the start field, choose 4.
b In the control field, choose Enable. c Click Apply.
13In the Dial on Demand ISDN Setup section of the navigation frame, click the PATH CONTrol link.
a In the start field, choose 3.
b In the CONTrol field, choose Enabled. c Click Apply.
14Enable IP routing.
a In the Basic IP section of the navigation frame, click the IP CONTrol link.
b In the CONTrol field, choose ROute. c Click Apply.
