20CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER
5Enable dynamic dial on the port.
a In the Dial on Demand Dynamic Dial section of the navigation frame, click the PORT CONTrol link.
b In the start field, choose 4.
c In the CONTrol field, choose Enabled. d Click Apply.
Configuring Network Addressing for Your Network
To configure network addressing, use either “Configuring IP Network Addressing” or “Configuring IPX Network Addressing,” depending on which protocol your network uses.
Configuring IP Network Addressing
Use this procedure when you use IP as your network protocol. If you use IPX as your network protocol, go to “Configuring IPX Network Addressing” on page 23.
To configure IP network addressing, follow these steps:
1Obtain an address range to be assigned as the address pool for the DHCP server from your network administrator.
2Assign the new IP address pool to the DHCP server.
a In the Basic IP section of the navigation frame, click the DHCP AddressPool link.
b In the start field, choose 1.
c In the AddressPool field, enter a DHCP address pool. For example, enter:
20.1.0.2- 20.1.0.254
dClick Apply.
3Enable the new DHCP address pool.
a In the Basic IP section of the navigation frame, click the DHCP CONTrol link.
a In the start field, choose 1.
b In the CONTrol field, choose AddressPool.
