16CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER
7Logically assign the two ISDN paths to port 4.
a In the Dial On Demand ISDN Setup section of the navigation frame, click the PORT PAths link.
b In the start field, click the arrow and choose 4. c In the PAths field, enter 2.1, 2.2.
d Click Apply.
8Enable all paths on port 4.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH CONTrol link. b In the start field, click the arrow and choose 2.1 c In the end field, click the arrow and choose 3.
d In the CONTrol field, click the arrow and choose Enabled.
e Click Apply.
9If your line speed requirements are different than the default (64 Kbps), you need to modify your path baud rate configuration.
a In the Dial On Demand ISDN Setup section of the navigation frame, click the PATH BAud link.
b In the start field, click the arrow and choose 3.
c In the BAud field, enter your path baud rate. For example, enter:
128
d Click Apply.
Configuring ISDN (Outside North America)
To configure Office A outside North America, follow these steps:
1Configure ISDN Dial on Demand.
Within IP Routing Configuration, set the primary and secondary phone numbers as provided by your telecommunications carrier for the ISDN paths.
a In the Dial on Demand ISDN Setup section of the navigation frame, click the PATH LocalDialNo link.
