Internal Modem Installation with Windows 3.x

The jumper shunts will be hanging from single jumper pins as shown in the following illustration.

4.To change the COM port and IRQ settings, you need to reposition the jumper shunts on the COM port and IRQ pins. To do this, lift the jumper shunts off the pins.

Grasp the jumper shunts with a tweezers or needle-nosed pliers. DO NOT grasp too firmly, as you may crush the shunts. If a jumper shunt seems stuck, gently rock it back and forth as you lift. Do not touch any other part of the modem or your computer with the tweezers/pliers. A shunt needs to be sitting on both jumper pins in order to effectively set the modem to the desired setting.

5.Move the jumper shunt to the new setting.

The COM port setting can involve one to three shunts. The four possible COM port settings are as follows:

Unlike most COM port settings, the IRQ setting involves only one jumper shunt. Simply move the jumper shunt to the pins labelled with the IRQ you need.

56K Voice Faxmodem Internal - User’s Guide

23

Page 29
Image 29
3Com 1.024.1644-00 manual