11Click OK.
12In the Network Adapters dialog box, click Close.
13In the Network Setup dialog box, click OK.
14If prompted, supply the information you gathered before you began the installation. After you enter the information, click OK.
A message appears, prompting you to restart your PC.
15Click Continue instead.
16If you are not using Card Services and you have a memory manager (all PCs running Windows have a memory manager), you must exclude the CIS memory address range for the PC Card and other Card Services devices.
For more information, see Appendix A. The driver installation is complete.
AutoLink for Windows 3.x, Windows for Workgroups, and DOS
If only one PC Card has been installed, you can use 3Com’s AutoLink™ software program to automatically install the NetWare ODI client software (including the driver), and to modify the CONFIG.SYS and AUTOEXEC.BAT files.
To use the AutoLink program, the PC must meet these requirements:
■Use Novell NetWare 3.12, 4.10, or 4.11 network operating system
■Have only one 3C589D PC Card installed
■Be intended for use as a NetWare DOS ODI client To use the AutoLink program, follow these steps:
1Make sure the 3C589D PC Card is installed and connected to the network, as described in Chapter 2.
2Boot the PC under DOS.
3Insert the EtherDisk diskette into drive A, type the following at the DOS prompt:
a:install [Enter]
