3Com VFD-D D manual Same time, but without reaction

		Chapter 4 Parameter SettingsDD Series
Parameter	Explanation	Settings	Factory	VF	VFP	SVC	FOC	FOC
			Setting
		Bit6=0 OD and CD signal are input at the
		same time, but without reaction.
		Bit6=1 OD and CD signal are input at the
		same time and with door
		opening
		Bit7=0 When the running signal come
		from an external terminal.
		Pressing OD and CD buttons to
		return to running status is not
		supported when the drive is
		stopped.
		Bit7=1 When the running signal come
		from an external terminal.
		Pressing OD and CD buttons to
		return to running status is
		supported when the drive is
		stopped.
06.11	Position Control Mode	0: No limit signal, detect by PG number	0	○	○	○	○	○
		and current level.
		1: Door open limit signal only, door close
		by PG number or current level
		detection.
		2: Door close limit signal only，door open
		by PG number or current level
		detection.
		3: Door open and close limit signal
		4: Detect by PG number and also accept
		external door open/close limit signal
		5: No limit signal, detect by PG number
		and current level. (For Pr.00-09=3
		speed control mode)
06.12	Stall Current Level of	0.0~200.0% (Drive’s rated current)	30.0	○	○	○	○	○
	Position Mode
06.13	Door Open/Close Holding	0.0~99.99sec	2.0	○	○	○	○	○
	Time Before Next Demo
06.14	Times of Door Open/Close	0~9999	0	○	○	○	○	○
	in Demo Mode (L)
06.15	Times of Door Open/Close	0~9999	0	○	○	○	○	○
	in Demo Mode (H)
06.16	Clear Demo Mode Door	0: Disable	0	○	○	○	○	○
	Open/Close Record	1: Clear (Pr.06.14 and Pr.06.15)
06.17	Present Fault Record	0: No fault	0	○	○	○	○	○
06.18	2nd Most Recent Fault	1: Over-current during acceleration	0	○	○	○	○	○
	Record	(ocA)
06.19	3rd Most Recent Fault	2: Over-current during deceleration	0	○	○	○	○	○
	Record	(ocd)
06.20	4th Most Recent Fault	3: Over-current during steady speed	0	○	○	○	○	○
	Record	(ocn)
06.21	5th Most Recent Fault	4: Reserved	0	○	○	○	○	○
	Record
06.22	6th Sixth Most Recent Fault	5: Reserved	0	○	○	○	○	○
	Record
		4-15