3Com VFD-D D manual Functions Descriptions

Chapter 4 Parameter SettingsDD Series

	8: 1st, 2nd acceleration/deceleration time selection	○	○	○	○	○
	9: Force stop (NO) input	○	○	○	○	○
	10: Demo mode	○	○	○	○	○
	11: Emergency stop (NO) input	○	○	○	○	○
	12: Source of operation command (Keypad/External terminals)	○	○	○	○	○
	13: Parameter lock enable (NC)	○	○	○	○	○
	14: Door open complete signal	○	○	○	○	○
	15: Door close complete signal	○	○	○	○	○
	16: Door open speed switch signal	○	○	○	○	○
	17: Door close speed switch signal	○	○	○	○	○
	18: Open allowance signal	○	○	○	○	○
	19: Screen signal input	○	○	○	○	○
	20: Door curve signal input for 2nd set door open/close	○	○	○	○	○
	21: Reset signal input	○	○	○	○	○
	22: Input system security circuit confirmation signal (DCC)	○	○	○	○	○
	23: Input enforced door closing signal (NUD)	○	○	○	○	○
This parameter selects the functions for each multi-function terminal.

Summary of Function Settings:

Settings	Functions	Descriptions
0	No function	Any unused terminals should be programmed to 0 to insure they
		have no effect on operation.
1	Multi-step speed command	1When door control mode (Pr.00-09)is set 2 (multi-step speed
2	Multi-step speed command 2	control), these four inputs can be used for 16 step speed
		frequencies
3	Multi-step speed command 3
4	Multi-step speed command 4
5	Fault reset	Reset drive setting after fault is cleared.
	Low speed operation	Before using this function, please make sure that AC motor drive is
6		stop. At this moment, key “STOP” on the digital keypad is still valid.
		When this contact is OFF, motor will stop by deceleration time of
		low speed operation.
	OD/CD command for low	ON: open the door (OD)
7	speed operation	OFF: closer the door (CD)
		This command will be effective only when external terminal for low
		speed operation is active.
8	1st, 2nd	When signal is input, the AC motor drive can switch between 1st
	acceleration/deceleration	and 2nd acceleration/deceleration time
	time selection
	Force stop (NO) input	This parameter has the same function as the “STOP” command
9		and no error message will be displayed. It does not require a
		RESET but a new RUN command is needed for the drive to run
		again.
10	Demo mode	When this setting is enabled, the output frequency of AC motor
		drive will run by open/close curve repeatedly till this setting is
		disabled. It will get the best open/close curve by this action.
	Emergency stop (NO) input	When setting to 11, the Multi-Function Input Terminal can be used
11		to stop the AC motor drive in case of malfunction in the application.
		It will display “EF”. Please “RESET” after the fault has been
		cleared.
	Source of operation	ON: Operation command via Ext. Terminals
12	command (Keypad/External	OFF: Operation command via Keypad
	terminals)	Pr.00-14 is disabled if this parameter is set to 13.
13	Parameter lock enable (NC)	When this setting is enabled, all parameter reading value will be
		00. This setting must be disabled in order to read the parameter
		content.
		4-39