![](/images/new-backgrounds/1108508/108508207x1.webp)
104CHAPTER 4: USING RF
Apply a Radio | When you create a MAP, a new radio (or radios, depending upon the type |
Profile to Each | of MAP created) are added into 3WXM. The radios use the default radio |
Radio | profile in 3WXM unless you create a new radio profile and apply it to |
| each radio on the MAP. |
| For more information about creating a radio profile, see “Create a Radio |
| Profile and Map the Service Profile to It” on page 100. For more |
| information about creating an MAP, see “Create Your MAPs” on |
| page 101. |
To apply a radio profile to a radio
1Select the Configuration tool bar option.
2In the Organizer panel, click the plus sign next to the WX switch.
3Click the plus sign next to Wireless.
4Select Radio Profiles.
5In the Radio Profiles table, select the radio profile.
6Click Properties.
7Click the Radio Selection tab.
8Select the radios in the Available Members list and click Move.
9Click OK.
You have completed the necessary steps for configuring your RF environment.
What’s Next? After you create your services (“Configuring Wireless Services” on page 51) and following the instructions in this chapter to create your RF environment, you need to deploy your configuration and enable monitoring. Optionally, you can improve your network monitoring options by modelling your floor and defining RF obstacles.
For information about monitoring your network, see “Managing and Monitoring Your Network” on page 155.
For information about enhancing RF