3M 800r3 manual BOX Size Capacity of Case Sealer

Installation and Set-Up (Continued)

Figure 2-1 – Conveyor Bed Height Adjustment and Lower Tape Drum Bracket Position

OUTBOARD TAPE ROLL MOUNTING (Lower	BOX SIZE CAPACITY OF CASE SEALER
Taping Head Alternate Position)

Remove the tape drum bracket assembly, spacer and fasteners from the lower taping head. Install and secure on the infeed end of the lower frame, as shown in Figure 2-1B.

TAPING HEADS

Tape Width – the taping heads have been pre- set to accommodate 72 mm [3 inch] wide tape rolls. To apply 48 mm [2 inch] or 42 mm

[1.75 inch] wide tapes, refer to Section II, "Adjustments – Tape Web Alignment", page 11.

Tape Leg Length – taping heads are pre-set to apply 70 mm [2.75 in] long tape legs. To change tape legs to 50 mm [2.0 inch], refer to Section I, "Special Set-Up Procedure – Changing Tape Leg Length", page 24.

At its factory setting, the case sealer handles box sizes up to 533 mm [21.00 in] maximum height. If larger capacity is needed, the machine can be adjusted to accommodate boxes up to 644 mm [25.38 in] high. Refer to page 24, "Special Set-Up Procedures – Outer Column Re-positioning", for set-up procedure.

Note –Adjusting machine to accommodate 644

mm[25.38 in] high boxes also increases minimum box size to 232 mm [9.12 in].

11