3M 800r3 manual Important Safeguards, 1 - Knife Warning Label, 2 - Electrical Warning Label

Important Safeguards

This safety alert symbol identifies important messages in this manual.

READ AND UNDERSTAND THEM BEFORE INSTALLING OR OPERATING THIS EQUIPMENT.

Important –In the event the following safety labels are damaged or destroyed, they must be replaced to ensure operator safety. A label kit, part number 78-8113-6778-4 is available as a stock item or individual labels can be ordered. See Parts Illustration/List, Section I, pages 66 and 67.

Two "Warning Sharp Knife" labels, shown in Figure 1-1, are attached to both sides of the upper assembly at the location of the cut-off knife on the upper taping head. The labels warn operators and service personnel of the very sharp knife used to cut the tape at the end of the tape application.

Figure 1-1 – Knife Warning Label

The "Warning - Hazardous Voltage" label, shown in Figure 1-2, is attached to the electrical enclosure on the lower right side of the machine frame. The label warns service personnel to unplug the power supply before attempting any service work on the case sealer.

Figure 1-2 – Electrical Warning Label

The two "Warning – Keep Away From Moving Belts" labels, shown in Figure 1-3, are located on each side of the top surface of the machine bed at the infeed end. These labels warn operators and service personnel to keep hands away from this area when the drive belts are running.

Figure 1-3 – Hands Warning Label

3