3M 800r3 manual WARNING - Use care when working with compressed air, 2 - Pneumatic Connection

Installation and Set-Up (Continued)

PNEUMATIC CONNECTION

WARNING – Use care when working with compressed air.

The case sealer requires a 6.5 bar gauge pressure [95 PSIG], 110 litre/min @ 21° C, 1.01 bar [3.75 SCFM] compressed air supply.

Using customer supplied air hose (8 mm [.31 in] I.D.) and clamp provided with machine, connect plant air to barbed fitting on inlet side of "On/Off" valve. See Figure 2-2. Note: If another type of connector is desired, the barbed fitting can be replaced with the desired 1/4-18 NPT connector.

Note –The air valve has provisions for lock out/tag out according to plant regulations.

Figure 2-2 – Pneumatic Connection

ELECTRICAL CONNECTION AND CONTROLS

The electrical control box, located on the lower right side of the machine frame, contains the pre-set circuit breaker. The control box can be located on the opposite side of the machine frame if desired. A standard three conductor power cord with plug is provided at the back of the electrical control box for 115 Volt, 60 Hz, 6.4 Amp electrical service. The receptacle providing this service shall be properly grounded. Before the power cord is plugged into 115 Volt, 60 Hz outlet make sure the red "Off" button is depressed and that all packaging materials and tools are removed from the machine. Do not plug electrical cord into outlet until ready to run machine.

Note –Machines outside the U.S. may be equipped with 220/240 Volt, 50 Hz systems or other electrical requirements compatible with local practice.

INITIAL START-UP OF CASE SEALER

After completing the "Installation and Set-Up" procedure, continue through "Operation" for tape loading and start-up to be sure case sealer is properly adjusted to run boxes.

12