INSTALLATION INSTRUCTIONS
FITTING AND ARRANGING THE COALS (Both NG & LPG versions)
Ensure the appliance is cold
Safety Notice - Please see SAFETY NOTICES ref. Coal / Log sets page 3.
Warning: The coals and the coal matrix are fragile ensure they are handled carefully.
Ensure location is correct. Do not force the matrix into position. If the coals and/or the coal matrix are damaged they must be replaced with genuine Aarrow parts.
Warning: An incorrect coal layout may cause soot to build up inside the stove and therefore invalidate the guarantee.
Centre Coal
Position
Pilot
Notch
Fig. 10a
3)Now position one of the loose coals into the centre of the stove ensuring that it is placed into the centre cutout and when in position, this coal will be resting upon the four corners of the base matrices. See Fig. 10a & b.
RR
LR
RF
LF |
|
11X |
|
LOOSE |
|
COALS | Fig. 9 |
How to arrange the coals
(see Fig 9 for part identification)
1)Place the 2x larger base matrices at the rear of the burner. These are labelled LR (left rear) & RR (right rear). These should be positioned so that the slots in the matrices sit over the rear upright fold of the burner top plate.
2)Next position the 2x smaller base matrices between the rear matrices and the front of the fire- box. These matrices are labelled, LF (left front) & RF (right front). The RF matrix has a notch in the front to avoid the pilot assembly.
The arrangement should look like Fig 10a.
Fig. 10b
Plan View Of Base Matricies - White Dots Indicate Loose Coal Positions / Cut outs.
4)Next, take 6x coals and place along the front row of the base matrices, 3x to the left of the cen- tre coal and 3x to the right of the centre coal. Observre the cutout positions within the matices as shown in Fig. 10b & 10c.
Fig. 10c
5)Take the remaining 4x coals and place along the upper edge to the base matrices. Again, place the coals into the areas shown in Fig 10b. The coal set layout is now complete and should look like Fig 10d & 10e.
14 | Aarrow Sherborne GSL CF |
