Acer Z5610, Z5600 manual Speaker Failure, Sound Problems

Speaker Failure

If the internal speaker fails, use the following flowchart to determine the required action:

START

Speaker

function failure

Check speaker			Reconnect
		NG
cable connection			cable correctly
	OK		NG
Check speaker				Replace
		NG		speaker
module
				module
			NG
	OK
				Replace
			Mainboard

OK Close

OK Close

OK Close

Sound Problems

If sound problems are experienced, perform the following actions one at a time to correct the problem.

1.Reboot the computer.

2.Navigate to Start´ Control Panel´ System and Maintenance´ System´ Device Manager. Check the Device Manager to determine that:

•The device is properly installed.

•There are no red Xs or yellow exclamation marks.

•There are no device conflicts.

•No hardware is listed under Other Devices.

3.Roll back the audio driver to the previous version, if updated recently.

4.Remove and reinstall the audio driver.

5.Ensure that all volume controls are set mid range:

a.Click the volume icon on the taskbar and drag the slider to 50. Ensure that the volume is not muted.

b.Click Mixer to verify that other audio applications are set to 50 and not muted.

6.Navigate to Start´ Control Panel´ Hardware and Sound´ Sound. Ensure that Speakers are selected as the default audio device (green check mark).

NOTE: If Speakers does not show, right-click on the Playback tab and select Show Disabled Devices (clear by default).

7.Select Speakers and click Configure to start Speaker Setup. Follow the onscreen prompts to configure the speakers.

8.Remove and recently installed hardware or software.

Chapter 4 109