12:35

Through out the

Activity test, point the remote toward your devices.

Begin Test

12:35

Reconnect USB to

verify Activity.

Test again

Test the entire activity

The next screen lets you test the “Good Night” activity with your entire system. IMPORTANT: Make sure all your devices are on before you start. Also make sure your remote is pointed directly at your home theater. Then select Begin Test. The screen says “Sending” while the remote is sending the power commands.

Did it work?

The next screen asks if the activity worked—if your devices turned off.

If it worked: Reconnect the remote to your PC (see the heading below).

If it didn’t work: Make sure your remote is pointed directly at your home entertainment devices and that there’s nothing obstructing the path, then select the Test again button. IMPORTANT: Make sure all your devices are on before you start. Test each device by selecting its on-screen soft key.

Then select OK to proceed and Begin test to test the entire activity again.

Try several times with the remote in different positions. If it still doesn’t work, go ahead and reconnect to PC to troubleshoot and correct the activity.

Reconnect the remote to your PC

Once you’ve reconnected the remote, press Continue on the EZ-RC™ Remote Control Setup Wizard screen.

How do I know the remote’s connected?

Look for the green arrow icon in your PC’s status bar.

Act v t es

Activities

23

Page 23
Image 23
Acoustic Research ARRX15G setup guide How do I know the remote’s connected?