Connect
Step 3. Wait for the bridge to start up
After connecting the power and Ethernet cable, the
WAIT | READY |
STATUS | STATUS |
LIGHT 2 | LIGHT 2 |
STEADY | BLINKING |
STATUS | MAY TAKE | STATUS | BOTH LIGHTS | |
LIGHT 1 | LIGHT 1 | |||
UP TO | ALTERNATING | |||
BLINKING | BLINKING | |||
30 MINUTES | BLINKING |
After plugging in the AC adapter the bridge will automatically perform the following boot operations:
| Startup Sequence | duration | STATUS LIGHT 1 | STATUS LIGHT 2 | |
1 | Initial Boot | 30 | STEADY | STEADY | |
|
| seconds |
|
| |
2 | Downloading | 5 to 30 | BLINKING | STEADY | |
| firmware from | ||||
| minutes | RAPIDLY | |||
|
| ||||
|
|
|
| ||
|
|
|
|
| |
3 | 30 | STEADY | STEADY | ||
seconds | |||||
|
|
|
|
| |
4 | Ready for Use | READY | BLINKING | BLINKING | |
RAPIDLY | RAPIDLY | ||||
|
|
| |||
|
|
|
|
| |
|
| 6 |
|
|
Step 4. Prepare the Bridge for Registration
The
Before you can access all this wonderful information, you must first “make the connection” by registering your bridge.
1.Make sure that BOTH status lights are blinking rapidly.
2.Press AND HOLD the “REGISTER” button on the bottom of the
BLINKING
BLINKING
Acu-Link Tip
Press the “REGISTER” button only once during initial installation. DO NOT PRESS THE REGISTER BUTTON AGAIN AFTER YOUR BRIDGE HAS BEEN SUCCESSFULLY REGISTERED, or you will lose previously stored weather data and have to register again!
7