2.7Other Standard Installation Procedures
This section contains other procedures done at every installation after the RAN is mounted on a wooden pole or concrete pad.
2.7.1Installing a Solar Shield
Each RAN has a solar shield that mounts on top of the cabinet. Hardware for the solar shield can be found in a bag fastened to the inside of the battery compartment. The hardware consists of two 1/4 in. bolts, each with flat washer and sealing washer. Use the following procedure to install the solar shield. Refer to Figure 31.
1.Remove the solar shield from its packaging.
2.Place a lock washer and flat washer and then the sealing washer on each 1/4 in. machine bolt.
3.Using the key provided, open the RAN door.
SOLAR
SHIELD
RUBBER
SEALING 
WASHER
TANGS
FLAT
WASHER
1/4 x 20
HEX HEAD 
BOLT
EACH SIDE
Figure 31. Installing the Solar Shield
Page 43
© 2007, ADC Telecommunications, Inc.