Note: For a description of the module including function, controls, and indicators, refer to Section 1.7.7 on Page 19. For a RAN chassis interconnection diagram, refer to Figure 40 on Page 58.
Use the following procedure to install an RUC2.X or RUC3 module (Figure 46):
1.Identify the designated chassis slot for the RUC module. This will be Slot 11 or 14. For more information, see introductory text above.
2.Remove the RUC module from the
3.Slide the RUC module into the designated slot within the RAN cPCI chassis.
4.Lock the IEL handles on the top and bottom of the RUC module into the cPCI chassis and tighten handle screws.
Figure 46. Installing an RUC Module
5.Using cable 1955000P079, connect the CH1/3 connector on the RUC module to either of the following as appropriate:
–RF IN port on PAA1 if RUC module is in slot A2
–RF IN port on PAA3 if RUC module is in slot A5
6.Using cable 1955000P079, connect the CH 2/4 connector on the RUC module to either of the following as appropriate:
–RF IN port on PAA2 if RUC module is in slot A2
–RF IN port on PAA4 if RUC module is in slot A5
Page 65
© 2007, ADC Telecommunications, Inc.