ADCP-75-210 • Issue 1 • March 2007

•Three nuts, three flat washers, three 3 in. square curved washers, and three split ring washers for bolts

Materials Required, ADC Supplied:

•RAN fixturing angle P/N 1001509P001 (X2)

•1/4-20 X 3/4 hex bolts (X4)

•2 in. through hull bulkhead fitting

•Flexible grommet

Use the following procedure to install an expansion RAN. Refer to Figure 39.

Note: This procedure assumes that the expansion RAN is installed on a utility pole directly above the existing RAN.

1.Open the existing RAN door.

2.Remove the solar shield from the existing RAN. Refer to the solar shield installation procedure in Section 2.7.1 on Page 43 and do the steps in a reverse order.

2 IN. (5.08 CM)

BULKHEAD FITTING

SUPPLIED WITH EXTENSION RAN

1.50IN. (3.8 CM)

KENNARD

FLEXIBLE GROMMET

SUPPLIED WITH

EXTENSION RAN

21296-A

Figure 39. Dual RAN Pole Mount

Page 55

© 2007, ADC Telecommunications, Inc.