ADTRAN 61200051L1, 1200051L6, 1200051L2, 1200051L5 user manual SBus Termination Menu Tree

Chapter 6. Configuration

When Call Screening is set to Ansr if SN0. . .9, an incoming call is not answered if the Call ID received from the switch does not match a stored number. Depending on the switch type, the Call ID may be presented in either a seven- or ten-digit format. The ISU 2x64 displays the Call ID for all dumped calls in the Status Buffer. See Status Buffer on page 20 for more information.

Because different switches handle calls and Call ID differently, first find out if the switch uses a seven- or ten-digit Call ID for- mat. Use the following procedure to determine if a seven- or ten- digit Call ID (phone number) should be stored.

1.Select Ansr if SN0. . .9 under Call Screening.

2.Store the seven-digit number in SN0.

3.Place a call to the ISU 2x64 with the stored number to see if it answers properly.

4.If the ISU 2x64 does not answer the call, check the Call ID message in the Status Buffer. More than likely, the Call ID number will be a ten-digit number.

5.Reenter the number in SN0 as it is displayed in the Call ID message and test Call Screening again.

SBus Termination

Use the SBus Termination option (see Figure 6-12) to select 100 ohm termination resistors for the S/T interface on ISU 2x64 units that are equipped for the ISDN S/T interface. These units (part numbers 1200051L2, 1200051L4, 1200051L5, and 1200051L6) con- nect to the S/T interface of an NT1 device or the S/T line card.

3=CONFIG

1=Netw. options

2=DTE options

3=Protocol

4=Quick setup

5=Security

6=Remote Config

1=Dial Line

2=Leased Line

1=Switch protocl

2=Call type

3=Terminal ID

4=Busy Out

5=Dial options

6=Auto answer

7=Answer tone

8=Connect Timout

9=Call Screening

0=SBus Terminati

1=100 ohm On

2=100 ohm Off

Figure 6-12

SBus Termination Menu Tree

46 ISU 2x64 Dual Port ISDN Service Unit User Manual 61200051L1-1D