ADTRAN 61200051L1, 1200051L6, 1200051L2, 1200051L5 Data Bits Menu Tree, Bis Async Menu Tree

Chapter 6. Configuration

3=CONFIG

1=Netw. options

2=DTE options

3=Protocol

4=Quick setup

5=Security

6=Remote Config

1=Asynchronous

2=Synchronous

1=Bit Rate

2=Connector Type

3=RTS Options

4=CTS Options

5=CD Options

6=DTR Options

7=DSR Options

8=Flow Control

9=Data Format

	1=8 Data bits
1=Data Bits
2=Parity Bits	2=7 Data bits
3=Stop Bits
	Figure 6-7

Data Bits Menu Tree

The setting in Figure 6-8 allows for V.25 bis messages in asyn- chronous (start/stop) data format.

		1=Dial Line
	1=Netw. options	2=Leased Line
3=CONFIG	2=DTE options
	3=Protocol
	4=Quick setup
	5=Securtiy
	6=Remote Config

1=Switch protocl
2=Call type	1=Front Panel
3=Terminal ID
	2=RS-366
4=Busy Out
	3=AT commands	1=V.25 HDLC
5=Dial options		2=V.25 ASYNC
	4=V.25
6=Auto answer		3=V.25 BISYNC
7=Answer tone	5=Disabled
		4=V.25 HDLC FLAG
8=Connect Timout
9=Call Screening

10=SBus Terminati

Figure 6-8

V.25 bis ASYNC Menu Tree

Although V.25 bis allows asynchronous data format, asynchro- nous DTE is more likely to support the AT command set than V.25 bis.

V.25 SYNC HDLC Dialing

To set the Dial Options for V.25 HDLC, choose 1=V.25 HDLC from the front panel or the VT 100 terminal (see Figure 6-8 for the menu tree). This setting provides V.25 bis messages in bit-syn- chronous format (for example HDLC, SDLC, X.25). The bit-syn- chronous format is the most commonly used by V.25 bis.

This option specifies that the characters should be 7-bit ASCII, with the 8th bit ignored (it may be either 0 or 1).

61200051L1-1D ISU 2x64 Dual Port ISDN Service Unit User Manual 41