Advantech EKI-7657C user manual Commands Level, Command Level

After you have logged in to the system, you will see a command prompt. To enter CLI management interface, type in the “enable” command.

Figure 3.4: Command Line Interface

The following table lists the CLI commands and description.

3.1.1Commands Level

Table 3.1: Command Level

Modes	Access Method	Prompt	Exit Method	About This Model
	Begin a session with		Enter logout or quit.	The user commands available
	your switch.			at the user level are a subset
User EXEC		switch>		of those available at the
				privileged level.
				Use this mode to
				• Perform basic tests.
				• Display system information.
	Enter the enable		Enter disable to exit.	The privileged command is the
Privileged	command while in			advanced mode
	user EXEC mode.	switch#		Use this mode to
EXEC				• Display advanced function
				status
				• Save configuration
Global	Enter the configure		To exit to privileged	Use this mode to configure the
	command while in	switch(config)#	EXEC mode, enter	parameters that are going to
configuration	privileged EXEC		exit or end	be applied to your switch
	mode.
	Enter the vlan		To exit to user EXEC	Use this mode to configure
VLAN database	database command	switch(vlan)#	mode, enter exit.	VLAN-specific parameters.
	while in privileged
	EXEC mode.
	Enter the interface		To exit to global	Use this mode to configure the
	command (with a		configuration mode,	parameters for the switch and
Interface	specific interface)	switch(config-if)#	enter exit.	Ethernet ports.
	while in global		To exist to privileged
configuration
	configuration mode		EXEC mode, enter
			exit or end.

27 Chapter3