•Pull down the selection item and focus on 802.1Q then press
Apply 
to set the VLAN Operation
Mode in 802.1Q mode.
• Enable GVRP Protocol: Tick the checkbox to enable GVRP protocol. This checkbox is available while | ||
the VLAN Operation Mode is in 802.1Q mode. | ||
• Management VLAN ID: The default value is ‘0’ which means VLAN function in 802.1Q mode is not | ||
available. While this column field is filled with a value from 1 to 4096, the member ports of this VLAN | ||
can access the management interface. | ||
• Select the port you want to configure. | ||
• Link Type: there are 3 types of link type. | ||
¾ Access Link: Single switch only, it allows the user to group ports by assigning the same | ||
| Untagged VID. While this link type is set, the Untagged VID column field is available but the | |
| Tagged VID column field is disabled. | |
¾ Trunk Link: The extended application of Access Link. It allows the tagged frames go across | ||
| two or more switches by assigning the tag with VID to the frames. Having set this link type, the | |
| Tagged VID column field is available but the Untagged VID column field is disabled. | |
¾ Hybrid Link: Both Access Link and Trunk Link are available. | ||
• Untagged VID: Assign the untagged frame VID. | ||
• Tagged VID: Assign the tagged frame VID. | ||
• Click | 媖 | to have the settings taken effect. |
Figure 3.37: 802.1Q VLAN Configuration
Group Configuration
Edit the existing VLAN Group.
•Select the VLAN group in the table list.
69 | Chapter3 |
