Advantech EKI-7657C user manual Trunk Commands Set

bandwidth type all		Set interface ingress limit frame	switch(config)#interface fastEthernet 2
	I	type to “accept all frame”	switch(config-if)#bandwidth type all
bandwidth type broadcast-multicast-		Set interface ingress limit frame	switch(config)#interface fastEthernet 2
flooded-unicast	I	type to “accept broadcast,	switch(config-if)#bandwidth type broadcast-
		multicast, and flooded unicast	multicast-flooded-unicast
		frame”
bandwidth type broadcast-multicast		Set interface ingress limit frame	switch(config)#interface fastEthernet 2
	I	type to “accept broadcast and	switch(config-if)#bandwidth type broadcast-
		multicast frame”	multicast
bandwidth type broadcast-only		Set interface ingress limit frame	switch(config)#interface fastEthernet 2
	I	type to “only accept broadcast	switch(config-if)#bandwidth type broadcast-only
		frame”
bandwidth in		Set interface input bandwidth. Rate	switch(config)#interface fastEthernet 2
[Value]		Range is from 100 kbps to 102400	switch(config-if)#bandwidth in 100
	I	kbps or to 256000 kbps for giga
		ports,
		and zero means no limit.
bandwidth out		Set interface output bandwidth.	switch(config)#interface fastEthernet 2
[Value]		Rate Range is from 100 kbps to	switch(config-if)#bandwidth out 100
		102400 kbps or to 256000 kbps for
		giga ports,
		and zero means no limit.
show bandwidth	I	Show interfaces bandwidth control	switch(config)#interface fastEthernet 2
			switch(config-if)#show bandwidth
state		Use the state interface	switch(config)#interface fastEthernet 2
[Enable Disable]		configuration command to specify	switch(config-if)#state Disable
	I	the state mode of operation for
		Ethernet ports. Use the disable
		form of this command to disable
		the port.
show interface configuration	I	show interface configuration status	switch(config)#interface fastEthernet 2
			switch(config-if)#show interface configuration
show interface status	I	show interface actual status	switch(config)#interface fastEthernet 2
			switch(config-if)#show interface status
show interface accounting	I	show interface statistic counter	switch(config)#interface fastEthernet 2
			switch(config-if)#show interface accounting
no accounting	I	Clear interface accounting	switch(config)#interface fastEthernet 2
		information	switch(config-if)#no accounting

3.1.5Trunk Commands Set

Table 3.5: Trunk Commands Set

Netstar Commands	Level	Description	Example
aggregator priority	G	Set port group system priority	switch(config)#aggregator priority 22
[1~65535]
aggregator activityport		Set activity port	switch(config)#aggregator activityport 2
[Group ID]	G
[Port Numbers]
aggregator group		Assign a trunk group with LACP	switch(config)#aggregator group 1 1-4 lacp workp
[GroupID] [Port-list]		active.	2
lacp		[GroupID] :1~3	or
workp		[Port-list]:Member port list, This	switch(config)#aggregator group 2 1,4,3 lacp
[Workport]	G	parameter could be a port	workp 3
		range(ex.1-4) or a port list separate
		by a comma(ex.2, 3, 6)
		[Workport]: The amount of work
		ports, this value could not be less
		than zero or be large than the
		amount of member ports.

EKI-7657C _Manual_ed1 30